Everything is fine when I print on plain papper. But when I try to use "Laser Transparent", this is "ruins" magnetic field of Earth... Printed papper have ghost prints on it and printer toner dust on the bottom of the printed page. After printing on "Laser Trasparent" papper I need to use Clean procedure. When my printer do clean procedure ant print cleaning sheet of papper, dirt from the toner clogs both sides of the sheet. Then I need print again couple times on plain papper to get clean prints again. Evertyhing fine again on plain paper, till I try use "Laser Tansparent"...
Breinas
Paper settings is the problem.
Set it to the heaviest paper setting possible and try again.
You will notice that the printer prints slower... That's so the fuser can transfer enough heat to the paper and fuse the toner.
Set it to the heaviest paper setting possible and try again.
You will notice that the printer prints slower... That's so the fuser can transfer enough heat to the paper and fuse the toner.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
