T-Shirt Forums banner

Left my heatpress on overnight :(

15K views 13 replies 11 participants last post by  Pwear  
#1 ·
Yesterday I left my heatpress overnight, after a long tiring session printing t-shirts :(. No damage to heatpress, but it aches to think about the electricity I wasted and potential for fire if something had caught alight!

Does anyone have any sort of special tools/equipment that can turn off a heatpress at certain hours of the day? Or better yet, after a certain time of operation (ie, automatic shut off the power after max 5 hours of use?).

I'm looking at an electrical timer of sorts, but they seem more for lights (turning them on and off at certain times during the day).
 
#5 ·
You should be able to pick up one at Lowes or Home Depot. Just make sure that it will handle the amps. You will need one that can take up to 20 amps. You can set the on time and off time.
 
#9 ·
My very hi-tech (NOT) and expensive (NOT) solution to this problem was to install a work light that hangs over my press. The rule in my shop is that when the press is turned on, the light is turned on. It adds much-needed light to that area, so it's an easy rule to remember. When I shut off the overhead lights at night, the bright light in the corner becomes a very obvious reminder for me to shut off the press.
 
#12 ·
Not that this helps you with your press but for new press shoppers there are presses that can be programmed to turn on in the morning and off at night by day of the week. Also units with control boards that go in sleep mode (where the heater cools down) after a certain amount of time not in use.
 
#13 ·
Ahhh modern technology at it's finest. Now if the lower platen would heat up as an option, we could cook breakfast also.....eggs anyone?? :)
 
#14 ·
I bet you could reverse-cook eggs - cook the top, then flip them and cook the bottom. For lunch, get a conveyor dryer and toast up some sandwiches.

::this post not advice to be followed in any way...don't sue me over a spoiled meal if it doesn't work :D::