T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
Anytime from any software if I try and go over 720x720 the printer will start printing then about 4-6 passes in pause printing and run the platen out. reload and it starts about 6" below where it left off. please help I'm at my wits end this happens with any combination white or color. Using AcroRip but same issues with EkRip as well.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top