[Dead Wrong]

Has anyone ever tried to use the image clip paper to lay a base for dark tees and press jpss over top?
I did a search but didn't see anything along the lines of what im thinking about doing. Right now I only have my mono Laser and my hp inkjet printers available. I've recently been using either vinyl or opaque paper to get my smaller orders handled with dark tees.
I was wondering what would happen if i mixed the two. I've done shirts mixing jpss and opaque but that's only because opaque only needs a good 10-15 seconds of press time.
I'm kind of reluctant to try it because I don't want the world to implode or anything, but do you think this would work or would the image clip just peel right off while peeling the jpss hot?

 

[Rodney]

I haven't seen it done before...but if you pull it off, be sure to post your results

 

[Dead Wrong]

I am going to test it tonight. It's probably going to be a little bit of a task setting up for each different sheet that needs to be pressed but if it works it may be a good solution for those custom short run orders. Some of my customers don't want vinyl even before they see the quality so I hope this works.

 

[papo1123]

I am going to test it tonight. It's probably going to be a little bit of a task setting up for each different sheet that needs to be pressed but if it works it may be a good solution for those custom short run orders. Some of my customers don't want vinyl even before they see the quality so I hope this works.

what about the result? are they good or not?