T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi I have bought welcome embroidery software and am waiting for my brother pr650 to arrive. Have looked into machine settings in the software to set it up for my brother machine so I can send designs direct. But can't find brother. Have looked all over the Internet to find instructions. Can anyone help.
Thanks
 

· Registered
Joined
·
127 Posts
ok, I hope I understand your question. I have the wilcom deco studio and a babylock 6 needle. You will have to use the usb cord connected to you computer. Then when are ready to send the file to your machine you need to save as and select the drive that connect to the machine and it will show up there. Select the usb icon and your file will be on the machine to stitch out. Please let me know if you need further assistance.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top