[mgarick]

I Just got my t-jet express up and running after replacing the head...Dampers...and the Tanks... and have been doing some good graphics on white.....I just got my pretreat in and did some black shirts for test and the white underlay looks a little grey? What am I doing wrong and am I going to get this on Black? Is there a way to through out more ink? Some one said up the Saturation a bit but haven't found this yet...I am using FastRip and Fastartist. used 1440X720 HS in the Fastrip. Any help would be Thankful

Thanks in advance for your help..

 

[IYFGraphics]

Post a picture if you can, also the HS mode is by-directional which means that it prints every pass of the print head both directions, you might try the same mode not in HS which is uni-directional (no HS after it) sometimes that will lay down more even ink (better coverage/less banding) but is slower printing.

Hope this helps.