T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
199 Posts
Discussion Starter · #1 ·
I'm about to do 100 9.3 oz. Gildan DryBlend hoodies with a mixed media design (embroidery and screen printing). The front of the shirt has a 5" circle made of a satin stitch with two 2.25" beer mugs inside of the circle, all embroidered 20,000 stitches total. The screen printing will be done first and it fills the the rest of the front of the shirt.
Question is... which stabilizer should I be using on this design? I've been using 2.1 oz cutaway, but have noticed some puckering (?) after a wash or two. I have seen in videos that some use tearaway on sweatshirts (in the stores like Kohl's)... which would work best for this application?
Thanks much!!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top