T-Shirt Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
244 Posts
Discussion Starter · #1 ·

· Premium Member
Joined
·
2,547 Posts
Quality unit from Stahls or DK should be fine. I would suggest getting an automatic release press with a 16x20 platen size. Getting a press that you can thread shirts onto will make 2 sided printing much easier!
 

· Registered
Joined
·
5,861 Posts
If you were buying a new heat press which one would you buy for DTG.

I was looking at the DK20 but dang that things big, either that or the person in the video was tiny.

I see an older post here http://www.t-shirtforums.com/heat-presses-equipment/t115734.html. Any additional or updated input?


Recommend going with a US made unit. Geo Knight, Hotronix, Hix, and Insta are all very good brands. A 16 inch x 20 inch heat platen. And getting an automatic release model will make your production life much easier.

_
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top