T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Hello all, I would like some help spending my money......

I am about to buy a vinyal cutter, at least a 24" my question is do you think I should buy a bigger one.
Iwill be doing garments at first but I would like to do signs and maybe even some auto graphics and window tint... garments is what I am after but I want to make the most of the cutter...sooooooooo what do you think?

24"
30"
or even bigger?
 

· Registered
Joined
·
1,345 Posts
Well it all depends on the the size of the graphics your going to be making. I have seikitech 34" and never had to cut nothing over 20" inches yet, i do both vehicle graphix and t-shirts too. So either one will be fine.
 

· Registered
Joined
·
334 Posts
I have a gx24 and have been using it for a long time. I have never needed anything bigger yet. If I was buying and money was no issue I would buy a 36", just in case. If money was a issue, then I would buy the 24". The 30 is in the middle, not sure if the 4" would be worth it. Hope this helps.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top