T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
18 Posts
Discussion Starter · #1 ·
Hello once again. I just printed a high detail design on a shirt using a plastisol ink and it looked good but not great. It seemed a bit think and not soft to the touch. It was a white print on a black shirt so of course more than one pass. I was wondering if I would get better results with a water base ink in this situation or what? that being said does water base inks work best with a higher mesh count of 305 and up?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.