[Shockarooney]

Hi, Just purchased a second hand Mimaki CG-75FX cutter but unfortunately the seller has lost the supplied software ( Finecut ) that came free with it. I have been on to Hybrid who are the main Mimaki agents for a replacement copy but they refuse unless I pay for it. I have looked at the Mimaki website for software downloads but they only have upgrades or trial versions. Any help would be appreciated. Thanks

 

[Shockarooney]

Hi, Just purchased a second hand Mimaki CG-75FX cutter but unfortunately the seller has lost the supplied software ( Finecut ) that came free with it. I have been on to Hybrid who are the main Mimaki agents for a replacement copy but they refuse unless I pay for it. I have looked at the Mimaki website for software downloads but they only have upgrades or trial versions. Any help would be appreciated. Thanks

Sorry I have been misled. I was under the impression that this software came free, but have now been informed that although you get it normally with a new Mimaki cutter, it comes as part of a package. I apologise for my mistake.

 

[STM]

Do you still want a copy?

 

[Shockarooney]

Hi Simon, I managed to get a copy but thanks anyway. Andy

 

[jrplaza2008]

Do you still want a copy?

Hi Simon, I know this is a old post from you but I have the same problem, I'm looking for the signcut software. Do you have a copy? I have a mimaki cg-160 ft with no software. could you please help or anybody here at the forum?

 

[sloganise]

Hi All.
I am new to this forum. I have a request and hope that someone here will be kind and knowledgeable enough to help.

I am aware this is an old post, I have set up this same message in another seperate thread too.

Basically I have just purchased a secondhand Mimaki CG-60SR cutter on ebay. unfortunately it comes with no software or drivers etc. I have been looking into it and found I need Finecut. I can't see where I can download it. I can only see a trial download option on the Mimaki site or upgrades of the software.

I purchased it because of the optical eye wanting to cut around printed transfers etc.
I heard that finecut has a plugin for illustrator and corel (do they do it for inkscape?) and i thought this sounds like a good idea for me. Is there free software available

If anyone knows where i can find this software and the drivers also for the cutter and any advice at all I would be really really appreciative.

I use windows 8.1 64 bit operating system.

At present I have a Creation PCUT CR630 that I have been using with Signblazer elements for the past 10 years or so but both are a bit rubbish really.


Many thanks, Alex

 

[Steven Tandy]

I know I am 5 yeards late for this post. HAs anyone got the cutting software for the mimaki? Thank you in advance