T-Shirt Forums banner
1 - 8 of 8 Posts

· Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Hi guys...If i was gonna be using a cutter/plotter for my t-shirt designs then what material is it that you put into the cutter/plotter?
Is it Vinyl or is there other materials that you should use?

If it is vinyl that youre only supposed to use then is this the kind I should be using? Link below shows some on ebay Im looking at. http://cgi.ebay.co.uk/5-Mtrs-Mactac...544623338QQcategoryZ46742QQrdZ1QQcmdZViewItem

Im still all new to this.. so sorry if its a dumb question, but any help appreciated.
 

· Registered
Joined
·
1,063 Posts
There are many different materials you can use (vinyl, flock, foil, glitter, etc...). Beacon graphics: http://www.beacongraphics.com/apparel-materials.html is cheaper and has more selection than TLM.

The vinyl on ebay wont work (i dont think). That is probably just regular sign vinyl. You need heat transfer vinyl.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top