T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Im using a pcut ct-630
and every time i draw a square in signblazer (just say 50mm x 50mm) and then cut it, the first line is always slightly longer where the last line should join and the last corner it cuts curves in. this is making it difficult to weed and ofcourse its inaccurate

Any ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top