T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
108 Posts
Discussion Starter · #1 ·
I have a GCC expert 24. I have had it for about 2 years. The cutter has started to make a funny whinning noise as it cuts. It still cuts but it sounds like it is going to stop then it takes off again. Does that mean the motor is going out. Can you replace the motor or do you buy a new vinyl cutter.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.