T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
we have vertical lines running down the left hand side of prints so far we have cleaned out the tracks and rollers cleaned head rollers belt replace encoder strip done head alignment and still cannot get rid of them the nozzle check is perfect anyone got an answer ??:(
 

·
Registered
Joined
·
40 Posts
Discussion Starter #3
We have found out it is the ribbon cable that connect to the printhead if I put a sponge under them where they come out from the back of the printer it prints perfectly for about ten shirts then I have to wiggle them a bit and it goes again it needs new cables I think or cleaning it is a DTG viper never ending trouble the lines move up and down when I move the sponge so we have to do nozzle checks until we get it right then print at the moment :)
 
1 - 3 of 3 Posts
Top