[lesleysuzanne]

Hi there,I am new to the forum, I am from Australia.
My question: I have a Roland SP300V I am trying to cut a product called SeraMark and I am getting uneven cutting e.g cuts one area fine then doesnt cut through the next image.I have the gf set very high.

Can anyone help?
Regards
Lesley

 

[spiderx1]

The usual culprits would be the blade is not exposed enough. Along with a damaged or uneven cutting strip / plastic strip that runs left to right on the bed. Material flexing due to worn rollers and or vacuum adjust. After that we jump to down force selenoid or material thickness changing due to poor quality. I am assuming u have tried a new blade just for the heck of it.

 

[gerry]

Im thinking it might be the cutting strip is worn ... its the little strip of material that the blade cuts on.
Good luck with it, I cant think of anything else.