[coachpall]

I have run into a problem lately when I am trying to heat press any dri-fit material (ie. Under Armour, etc)

The press is leaving a mark on the material, it changes the color slightly. I even tried to put a small mouse pad just under the transfer, but it still leaves a "press mark" where the press hit the material.

Is there any way around this? Any help would be appreciated.

thanks

 

[Gueits]

Are you using a teflon sheet?

 

[COEDS]

The mark should go away when the material cools back to room tempature. .... JB

 

[coachpall]

it doesn;t...i never used a teflon sheet...i'll try that