T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have trouble with my machine, when I try to cut a big work ( 50x50 cm)....... The plotter begins well but when the Flexi send 80% of work, the machine AUTOMATICLY turn OFF in few second turn ON and RESET ....... the result a lot of waste material, I attach a photo of the work, in a minor size 30x30cm, because to make the job 50x50cm was impossible.

Please tell me what can I do???


Machine: Us Cutter LH-720

Material : 3 years Mactac and Gerber

Speed 20 inch/s

Pressure: 70grs

Software: Flexisign 7.5

Regards

benedettij
 

Attachments

·
Registered
Joined
·
1,959 Posts
Allot of the Chinese cutters that US Cutters sell have red buttons on either side of the carriage that act as some type of failsafe in case the blade holder runs into the side of the cutter. My guess is that the way you have your material loaded or the way you have your software configured is causing the blade holder to run into one of these buttons resetting your machine.

Chances are this cutter does not read material width, so you need to input that in your software.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top