[levelonegraphics]

Is there a trick to getting a good brite white ink lay down on black shirt. This is for a white print only.

 

[BQMatt]

Make your design in black and then in PowerRIP select "Use White Ink Only" as your White Layer Generation mode. If that is still not putting down enough ink you can slide the Density slider located under the White Layer Generation drop down box to the right and then click Create button again.

 

[JeridHill]

It also will depend on what type of shirt you are printing on. I've printed on Gildan that even after 2 passes of white ink (which should never be needed), the prints were not bright.