T-Shirt Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I've been having a problem with jpss and transjetII papers not wanting to feed into the c88+.Happened last night,10-12 sheets printed(only load 3-4 sheets at a time) go thru fine and then the printer can't seem to grab the next sheet.Thought maybe the c88+ was getting worn,so grabbed the new c88+ off the shelf(had a refurbed spare)and it did fine for about 15 sheets and started doing the same thing.Ran some regular printer paper thru a couple times and it seems o.k. now.Is this a humidity problem that makes the trans papers slippery?(was warm more humid than usual).On the old c88+,I tried cleaning the rubber grab rollers in the printer with alcohol and it works for a sheet or 2 and then happens again. Any ideas?
 
1 - 2 of 2 Posts
Top