T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Thoughts on Stylus Pro 7600 dtg conversion

I thought I posted this earlier, but I am not finding it. So, as David Coverdale says, here I go again.

I have been looking at the Chinese DTG machines and the DIY tutorials / builds. Has anybody tried converting a Stylus Pro 7600? My thoughts are that this printer already has the heavier duty drive system and the roll feed would probably be easier to convert.

Acrorip supports this printer as well. Thoughts?

Danny Pittman
Pittman Signs and Designs
Gainesville, Ga
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top