T-Shirt Forums banner

Thermocouple wire question....

1K views 6 replies 3 participants last post by  TABOB 
#1 ·
Hey Forum,

I have a swing away HP 5in1 press with an aiset YLE-2001 controller. My issue is a broken thermocouple wire for the platen. What I'm wondering is whether this controller needs a J-type or K-type wire.

Anyone have any info?

Thanks in advance!

Gauge Measuring instrument Fuel Gas Machine
 
See less See more
1
#6 ·
I am using a thermocouple (TC) that has a pair of wires that are attached to the leads. I have been told that these wires should not touch each other at any time, but there is no label on the TC box indicating this. Also, I was told that if they touched, the TC would be damaged, and that it could potentially cause damage to my equipment. Could someone please tell me whether or not what I have been told about the use of this particular TC is true? Thanks!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top