T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello, I just recently started working at a shop that has a single head Tajima Neo TEJT-C that has been sitting unused for a couple of years since the bought a more modern Barudan. I would like to get this machine back up running as it seems a waste to let it sit. I am hoping for some insight on what steps/maintenance/basics/troubleshooting/settings I should go over to get the machine going again. I believe it was working fine when it was retired just want to start off on the right foot. Greatly appreciate any advice or insight. Thanks in advance.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top