I have had to but a new Epson 1430 printer and trying to reinstall t-Rip 1.2
I have installed/ uninstalled and re installed 3 times and I'm having some trouble after 2 1/2 hours.
I have installed the software and set up the printer. When I go and do a test page it prints about 1inch of the test page and kicks the sheet out and errors out. I have tried and send a job thru Corel and the job show up but there is no preview and when you print it, it goes to holding with a red circle with a X.
If I go straight out of Corel and print not using Trip it works fine.
Any ideas?
I have installed/ uninstalled and re installed 3 times and I'm having some trouble after 2 1/2 hours.
I have installed the software and set up the printer. When I go and do a test page it prints about 1inch of the test page and kicks the sheet out and errors out. I have tried and send a job thru Corel and the job show up but there is no preview and when you print it, it goes to holding with a red circle with a X.
If I go straight out of Corel and print not using Trip it works fine.
Any ideas?
