T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I just replaced the printhead. Now the T-Jet will do ink charges and cleanings, but will not print anything.

It goes through the motions but won't even do a nozzle check.

Any ideas?

Thanks in advance for any help.

Sincerely:
Danny Smith
 

· Registered
Joined
·
1 Posts
Check your ribbon cable connections. Make sure everything is pushed in snugly. Also check for any burn marks at the connection points.

Harry
Equipment Zone

I am also having this problem... but I replaced the fuse in the back, the ribbon cable and the encoder strip as well... what else could possibly cause this?
could I have been sent faulty ribbon cables?
I do see a small (what seems to be a burn mark) mark in the same place on both my old and new replacement cables

ANY IDEAS?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top