T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I had a needle break and seize up my Hook Assembly. After getting it all fixed I attempted to embroider a shirt. After starting the machine it turned out that the needle that was being used was not the one selected on the file but some how was 4 needles ahead. #2 needle was being sewn by #6 and # was sewn by #7. Also they were only sewing about 10 stitches before shutting down and stopping. I read that the reason it was stopping was because the sensor was sensing another needle. Does anyone know how to fix the problem. thanks for any help.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top