I am using FlexiSign Pro and sending jobs to our Summa D60r to produce contour cuts.
My question is, is there a way to choose or force the start position of where the cuts begin..
The reason I ask this, is because sometimes the knife gets "stuck" partly out of the blade holder (yes I know I should have bought a tangential!) and if the start position is on the far left, then it can cut across the artwork as the knife blade is sticking out.
If I could have the contour cut start position somewhere on the right of the artwork, then this should resolve the problem.
Any ideas?
Thanks in advance
My question is, is there a way to choose or force the start position of where the cuts begin..
The reason I ask this, is because sometimes the knife gets "stuck" partly out of the blade holder (yes I know I should have bought a tangential!) and if the start position is on the far left, then it can cut across the artwork as the knife blade is sticking out.
If I could have the contour cut start position somewhere on the right of the artwork, then this should resolve the problem.
Any ideas?
Thanks in advance
