T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am new at printing stone coasters with my GT-541. I have had success with printing full color photos but not so much with a design I created. My design uses a light colored background to cover the total coaster area and then prints 2 darker colors on top of the background. It appears when used with a glass with condensation that ink is bleeding off. Small darker marks are appearing on the light background color. Help? Also, if you could share the steps you take (pretreatment, heat application, post-treatment), that would be very helpful,.

Thank you!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top