T-Shirt Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Good day.
I have Kornite Breeze 921
Problem with Heater & Sensor Element for the Heads.

The problem I ran into is that the temperature in the print head shows 68 to 32 degrees.
I found out that the Heater Sensor (Heating Element for the Heads) is faulty. But I can’t buy it anywhere. support Kornite said me that they do not have and they do not know when they will appear.
Maybe someone came across such a problem and was able to solve it. ?
 

·
Registered
Joined
·
1 Posts
I had a similar problem, from measurements made with an ohmmeter, I found the sensor element is a thermistor whose counterpart is NTC100K, i.e. a thermistor that should have a resistance of 100Kohm at 25 ° C. I have not found the original anywhere. I bought sensors like in the picture. I soldered it, replaced it and everything is fine.
273680
273681
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Тhanks . We still called again. And they found a set of heating element and temperature sensor. replacing them the problem is gone
 
1 - 3 of 3 Posts
Top