T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Gildan
Joined
·
43 Posts
Discussion Starter · #1 ·
Our Spectra 3000 had blinking lights yesterday and no power, so we have replaced the ribbons, power supply and the mainbroard (from another Epson R3000 - desparate measures). The printer is Ready now, but the software doesn't recognize it. Is there a way to link them now?

Thank you in advance for your input.
 

· Registered
Joined
·
531 Posts
Our Spectra 3000 had blinking lights yesterday and no power, so we have replaced the ribbons, power supply and the mainbroard (from another Epson R3000 - desparate measures). The printer is Ready now, but the software doesn't recognize it. Is there a way to link them now?

Thank you in advance for your input.
uninstall the oude rip software allready installed, install the software again.

What is your rip software?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top