T-Shirt Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi Folks, i am wanting to connect my laptop or pc to my embroidery machine (tajima 612).
i have wilcom 9 do i need any other software? what sort of cable do i need to connect either of them to the machine?


Cheers
 

·
Registered
Joined
·
17 Posts
i do embroidery but have not had the oppurtunity to purchase a commercial machine. but i have been looking and saw a few demos at show.
i will try and help but you should probably contact a rep from tajima.

you need to know weather or not you machine has a direct connection for a pc. normally a serial port or usb port on it and then you should be able to go directly from the pc to the embroidery machine.

some older machines and the home based models, like i have you need some sort of card reader / writer to save the design to a card or usb jump drive or floppy disk then you insert it into the machine.

all machines are different and with out knowing your specific machine it hard to say a real answer i would look through the manual or try and contact a rep.

good luck
 
1 - 2 of 2 Posts
Top