T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·

Does anyone know what are the correct settings to cut Flock material by Hot Films, using the Graphtec Craft Robo CC200-20?
The material is this one:

Flock Heat Applied Vinyl by Hot Fix Films 19" x BY THE FOOT - F-BTF

This material is kinda thick, which blade cap would be better (yellow or red) to cut this?
Has anyone had any experience cutting this flock with the cc200-20?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.