T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
I fixed the paper lever problem! However I ran into a new problem... the printer now says Service Req. 00010035, and when I open up the printer to see the DC board, it shows 4 small tiny light bulbs the size of a airsoft gun bullet, 3 lights are coming on, but the one that is marked [ "A" OK ] is not coming on. Any inputs?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.