T-Shirt Forums banner

Scoring / creasing?

892 Views 1 Reply 2 Participants Last post by  jiarby
Newbie question. On a good cutter (GX-24), can I have it cut partially through the vinyl, so that I can fold it over easily? I mean, say I am cutting 4 mil vinyl, can I have it only cut 1 mil deep in some areas and cut 4 mil deep in other areas. It can only cut from one side right?
1 - 2 of 2 Posts
vinyl will bend just fine with out a crease
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.