T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Looking for some guidance on Sublimated Sandstone coasters. Sawgrass SG1000, IronClad sublimation blank sandstone coasters, pressing @ 400 degrees for 210 seconds, medium pressure. I would say 3 out of 4 come out okay, not supper vivid but what I would expect on the sandstone, 1 not sure if there is ghosting on my images as they don't come out quite as crisp as a photo, or can't tell if the image is over saturated maybe due to pressing too long? Or would it be from my actual photo, (look clear on my computer) or is it the way I am printing/pressing ? Also using an 1/8 inch green pad per instructions.
 

·
Registered
Joined
·
2,615 Posts
Increase the time to 240 seconds.
If you see an improvement, try 270 seconds.
If you see an improvement again, try 300 seconds.
At some point it will start getting worse instead of better. At that point go back to the previous setting.
The black color is a good indicator.
 

·
Registered
Joined
·
1,617 Posts
Let me know if you need my help. That is a excellent suggestion. Are you pressing more than one at a time?


Sent from my iPhone using Tapatalk
 
1 - 3 of 3 Posts
Top