T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just purchased a Roland Stika SV-8 and am having a lot of fun learning and making vinyl transfer stickers.

One quick question -- I'm struggling to figure out how to align my cuts on the vinyl.

When I layout the paths in Illustrator, what should the width of my artboard be?

The printer tends to pull through about 4" of material first and then start cutting. The person who I bought it from used Roland's CutStudio software and it just cut straight from the top. Any videos or tips would be appreciated! Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top