T-Shirt Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi everyone

I am new to any type of plotters.
I just bought a used Roland GX24 and run into problems when I want to buy a new blade and it doent fit into the holder.
My blade is 1 mm thick, the new one I bought is 2 mm and the local seller is telling me the 2 mm is the right one.
Can anybode tell me whitch is right ?
1 mm or 2 mm

Regards to everyone
Bernard
 

·
Registered
Joined
·
276 Posts
Hi everyone

I am new to any type of plotters.
I just bought a used Roland GX24 and run into problems when I want to buy a new blade and it doent fit into the holder.
My blade is 1 mm thick, the new one I bought is 2 mm and the local seller is telling me the 2 mm is the right one.
Can anybode tell me whitch is right ?
1 mm or 2 mm

Regards to everyone
Bernard
Bernard,
2mm is the proper diameter for our factory blades. If this doesn't fit in your blade holder, you should probably look at replacing that too.

-Dana
 

·
Registered
Joined
·
52 Posts
Can anyone tell me if I can use my Roland GX24 to cut images out of card stock? How would this be done? Would I need some sort of backing?
Micki
 
1 - 5 of 5 Posts
Top