T-Shirt Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I print the image out on my workforce 1100 then i put the image into the gx-24 cutter>select piece. it reads the size ok. i click cut in Cut Studio, the cutter reads registration marks but when it cuts the top of the image is about 1/3 inch short, and the bottom and sides are fine. Please help.

Thanks
Rick

 

·
Registered
Joined
·
996 Posts
Not sure about your problem but I like your design. More to the point than "keep off the grass". lol
 

·
Registered
Joined
·
9 Posts
Discussion Starter #4
Thank you so much i checked the box and worked like a charm. do you know what that actually does vs non fine adjustment?
 
1 - 4 of 4 Posts
Top