T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi to all in the font of wisdom.
I am attempting to contour cut on a Roland GS24 using the latest flexisign pro.
After printing and loading the sheet the laser eye finds 3 of the 4 contour marks and cuts only problem is that the cuts are always off to the left about 3-4 mil
Is there a way to calibrate the machine?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.