T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
Do i need to use RIP software to get the paper sensor to align correctly and consistently? another thread i posted had a reply that suggested that i did, but im still not quite sure if it is true.

EDIT: i was able to get the printer aligned at exactly 1 inch, however, the printer head wouldnt move afterwards, and the two flashing red lights came on. any ideas on what this is?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top