T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I wasn't quite sure where to ask this so here goes. I've got a Ricoh MPC2500 laser copier/printer. I had the PostScript card put in it and when I use the PS fill in my CorelDraw it outputs perfectly. I'd like to print my transparencies with it but it won't do the halftones properly. When I send my small design to my Brother laser printer it prints halftone dots, when I send the same logo to the Ricoh it prints the shadow fill instead of the dots. Anybody got any ideas on how to set up the Ricoh or where to go for assistance. Ricoh doesn't know a thing about printing from Corel. I can run it through GhostScript but that changes even the areas I'd like to keep black to dots. That's not good either, but it does print the dots out of GhostScript.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top