[Lawdawglt]

Hello everyone,

Situated in Milford Pa, have a small shop where I do laser engraving and sublimation
(hard substrates ). Planning to start doing Tee Shirts so if anyone can has any advise on swing presses and cutters I would greatly appreciate your input.
Thank You

 

[DrivingZiggy]

What up dawg! There has been LOTS of discussion on which this or that is best. And like most things, a lot comes down to personal preference. But dig around! This forum is very active and I've been learning a lot. You will, too!

 

[azco79]

Hi! We have a few Summa cutters that are really nice but $$$ and some Rolands that are sorta middle of the road, fairly reliable.

 

[Amw]

For a plotter Summa, Graphtec, or Roland.
For a press, Geo Knight, Hix, or Stahls.

 

[Lawdawglt]

Want to thank you for your responses back to my post, I’ll keep searching the post and settle on the equipment that I’ll need. I think I’ll be getting a Geo Knight press and I’ve been looking at a Gcc cutter, believe that’s the brand.

 

[Lawdawglt]

Want to thank you for your responses back to my post, I’ll keep searching the post and settle on the equipment that I’ll need. I think I’ll be getting a Geo Knight press and I’ve been looking at a Gcc cutter, believe that’s the brand.