[Beachbumz]

Does anyone know if the motherboard on the HM1 can be repaired if blown?

 

[IYFGraphics]

Does anyone know if the motherboard on the HM1 can be repaired if blown?

Hey Ron....

If you have the board removed you can send it to SWF East. Equipment Zone, or American Screen Supply for repair, or if it's just the blown fuse (on the board) you can attempt to repair it yourself.

Here's their web sites.....

SWF East, Commercial Embroidery Machine and Direct to Garment Printer Sales

Direct-to-Garment Printers, Ink, Parts & Support | Equipment Zone | Screen Printing Equipment, DTG, Heat Transfer Presses

American Screen Supply - Best Prices on Inkjet Film and DTG Products!

Hope this helps....

 

[Beachbumz]

I saw on a post somewhere that someone soldered a fuseholder in place of the blown internal fuse for about 10 bucks. Do you know anything about this?

 

[IYFGraphics]

I saw on a post somewhere that someone soldered a fuseholder in place of the blown internal fuse for about 10 bucks. Do you know anything about this?

Never done it myself, but if you have ever did any soldering on a circuit board before you should not have any problems, I know Pat (fatkat printz) has done it and also helped others, you could PM him and ask, I'm sure he wouldn't mind helping.....or just wait till he responds here.

Pat will probably read this thread and respond, he and Carla are good people.

Hope this helps.

 

[FatKat Printz]

got 'em!! I haven't heard from the people that I have sent the directions to for the HM-1 so hopefully it works..

My directions are for the TJ2 and K2..