T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hey ya'll. Just a quick question...

I've found a tee supplier that I really like, however their tees always have lint (little bits of dust) engrained in the material. Once I place the tee under a heat press for 20 odd seconds, this lint all shows up and it's a PAIN!

I've tried various lint brushes, but this is very annoying and time consuming. Does anyone have a good solution to getting rid of this lint prior to printing? (Short of washing them)

Any ideas much appreciated, Bryn.
 

· Registered
Joined
·
10 Posts
Discussion Starter · #3 ·
Thanks for the tip. Unfortunately that won't work as this lint is very fine and stuck to the material fairly well. Even after brushing with a lint-removal brush, are still a lot of hairs etc visible...:(
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top