T-Shirt Forums banner

refill for my printer

1309 Views 5 Replies 4 Participants Last post by  lazographics
hi guys. anyone can give me an advise that what's the stand level if i want to refill the ink bottle, and what's the heights on the ink bottle tray should i make it

thanks
1 - 6 of 6 Posts
start out at 7 inches ( top of ink tray)
fill bottles to 4 oz. max
check printhead for ink drops
if you see drops lower ink tray
little bits at a time
  • Like
Reactions: 1
Keep all the inks at the same level always. Then adjust the ink tray to where the top of the ink level is leveled with the bottom of the print head. Do a head cleaning to level it out. If ink drips from the head then lower about 1/2 inch and do another head cleaning. If tray is to high ink will drip out of the head. To low then the print head will starve of ink.
  • Like
Reactions: 1
the white ink should be a little bit higher ...
  • Like
Reactions: 1
If your going to set the white higher make sure its only about 1/2 inch. Some issues that can happen if its to high you will see streaks of color when printing an underbase or your underbase can have a slight tint of color to it.
  • Like
Reactions: 1
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top