T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Help! I am printing a design that has red ink touching white ink. The white layer needs to be pushed first. I push the white, flash, then push the red. For some reason in a few places the red bubbles over on to the white. I have never had this happen before. I raised and lowered the red screen and still no change. I am printing on silver A4 cool performance shirts. Thanks for any help!
 

· Registered
Joined
·
707 Posts
If it's always on the same spot, I would use an IR heat gun and see if you have a hot spot on your flash unit. It's a good idea to check anyway so you aren't curing the white ink anyway. Also, make sure your shirt is cooled off sufficiently before printing the red.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top