Joined
·
19 Posts
Hi everyone,
I won some funds and decided to put it towards a quick connect system for Chromablast. My issue is that I have connected the system, but the tubing gets caught inside when the carriage is moving back and forth. If I give too much slack it catchs, If I line the tubing up the way that they say, its looks like its not long enough and it still gets caught. I end up standing at the printer and holding the tubing "up" while it prints. This is NOT an efficient way to run a business.
Does anyone have any feedback on what to do with my tubing? So far as I can tell, I hooked it up the way I was told to.
Candace
I won some funds and decided to put it towards a quick connect system for Chromablast. My issue is that I have connected the system, but the tubing gets caught inside when the carriage is moving back and forth. If I give too much slack it catchs, If I line the tubing up the way that they say, its looks like its not long enough and it still gets caught. I end up standing at the printer and holding the tubing "up" while it prints. This is NOT an efficient way to run a business.
Does anyone have any feedback on what to do with my tubing? So far as I can tell, I hooked it up the way I was told to.
Candace