T-Shirt Forums banner
1 - 1 of 1 Posts

53 Posts
Discussion Starter · #1 ·
i just got my hotronix 16x20 swinger today. it is used but looks to have been well taken care of. when i unpackaged it and went to plug it in i realized it had a 20amp plug on the end of the cord. my place only has the regular 15amp plugs which obviously don't accept the 20amp plugs.

what should i do? would cutting the cord at the end and replacing the plug itself hurt the functionality of the press? just curios cause i actually went and bout a 20amp outlet and tried to install it only to find a mess in the wiring. there is 4 wires and only 3 screws on the new outlet.

im confused....again....anyone have any suggestions.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.