[EP USA]

I am having major problems getting my film to print out all the way through for my logo. It is stopping about half way through the job and then just sending the film all the way through like it is done and only half of my logo is printed. Also it is printing a ghost like image near the design.

Also I am having to only put the art at the very top of the page.

I just got a new Epson 1430 and a Film Maker rip so I don't know what is going on.

Any help would be appreciated.

Thanks!

Glen W.

 

[sben763]

Did you install the control panel and then print to the epson 1430 and not the epson 1430 series printer. I am very firmiluar with filmmaker but I use the 1400. If need to you can pm me I can give contact info.

 

[EP USA]

Hey, I am printing from the Epson Photo Stylus 1430 printer. I had Fred from American Screen Supply help me get set up with everything.

He could seem to figure out why it was doing this either.


Thanks!

 

[screenvince]

I am having major problems getting my film to print out all the way through for my logo. It is stopping about half way through the job and then just sending the film all the way through like it is done and only half of my logo is printed. Also it is printing a ghost like image near the design.

Also I am having to only put the art at the very top of the page.

I just got a new Epson 1430 and a Film Maker rip so I don't know what is going on.

Any help would be appreciated.

Thanks!

Glen W.

Hi,
did you ever sort this out as my filmmaker is doing exactly the same thing, any ideas?