T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
47 Posts
Discussion Starter · #1 ·
I tried cutting a sticky flock template with my GCC Expert24 and a winpc 2014 design, I choose 2 passes to make sure the template material cut thru and the design cut fine but it was cutting the templates twice instead of just once. This was a alphabet template that I purchased online. I am sure it is a error on my part but just need help if figuring out what I did wrong. I tried to stop the cutting of the second set of templates by pushing pause on the gcc cutter and stop cutting on the winpc software with no results so I had to turn the cutter of to stop the cutter. How do you stop the design from cutting with this cutter and winpc 2014. Any help would really be appreciated.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.